11-4 Smart Switch 1800 4. 0 User Guide , Rev 0 1
175, 150, 300, 600, 1200, 2400, 4800, 9600, 14.4K, 19.2K.
2Relevant only if Physical Port Interf ace is some thing o ther th a n RS-232 and Generate
Clock
is Y.
3If the BSC port is connecting to a logical X.25 port in the SmartSwitch, Atcl must be set
to Y.
Port Type
specifies the protocol the p ort will support. Selec ting this parameter will d isplay a list
of all serial protocols loaded in the device.
Physical Port Interface
must be configured as follows. For reference, port locations are shown on page 6-1.
●Port 0 is always RS-232.
●Port 1 must be RS-232 if the port is being configured for BSC.
●Ports 2 and 3 are determined by the attached cables: RS-232, V.35, or RS-449.
Blocked Po rt Flag
will cause the port to be enabled (N) or disabled (Y) at node IPL. The port will remain
in that state until this parameter is changed or an on-line enable ([B], [B], [C] from the
Main Menu ) or d i sab le ([B ], [B], [A] from the Main Menu) is perf or med .
Line Speed
is the data transmission rate in bits per second, and the clock speed on a serial port
when the port is a physical DCE (i.e., the attached I/O cable is DCE). If this port is a
physical DTE, specify the line speed that matches (as closely as possible) that of the
device connected directly to the port.
Retransmission Period
is the length of time before the node will transmit an I-frame if the previous trans-
mission is not acknowledged. If the period expires, the timer will be reset an d a super-
visory frame will be transmitted demanding immediate acknowledgement. The
Maximum Retransmissions (see that entry) c ounter will also be incremented.
Delay Ti mer (sec) 1–10 1
Delay Retry Count 1–255 8
NAK Retry Count 1–255 5
VC to be Cleared After Disc Y/N N
Idle Timer (s ec) 5–180 10
Subsc riber I nform atio n
Sq 1–16 none
Local Sub 0–15 characters none
Remote Sub 0–15 characters none
Atcl (Autocal l) Y/N 3N
Rtytm (Retry Timer) (sec) 15–255 60
Rty # (Retry Number) 0–255 0 (i ndefin ite)
Del (Delete) see explanation n/a
Table 11-1 BSC Batch Port Parameters
Param eter Valid V a l ues Default V a lue
(continued)