Configuring BSC Interactive 10-9
1 The software does not verify that a specified port exists. Make sure all specified p orts are
config ured in the d atabase .
Subs criber N a me
identifies the subscriber to the console operator.
Routing Algorithm
allows creation of a "hunt group" of ports (see example o n page 8-22), fo r the purpose
of routing per a pre-selected algorithm:
0 = Round Robin – selects ports specified cyclicly in numerical order according
to the list of Redirection Addresses. If the selected port is unreachable or con-
gested, the Call Request will be sent to the next port. (If the port becomes
available again, it will be included in its assigned position.)
1 = Alternate Route on Line Failure – selects the first port that is not in a failed
state. If the selected port does not make a connection, th e call will be cleared, even
if other ports are available.
2 = Alternate Route on Line Busy – selects the first port that has LCNs available
(is not busy). If the port has failed, the next available port will be selected.
3 = Least LCN with Throughput – selects the line with the minumum loading, ca l-
culated by weight and number of LCNs in use on that line. (Each line is assigned
a weight proportional to its throughput within the routing path.)
If use of a routing algorithm is not desi red, simply accept th e default, an d specif y only
one routing path.
Systematic Redirection
will redirect (if Y) all calls to the alternate subscribers specified by the Redirection
Addresses. Consecutive attempts at ca ll redirection will be made to each a lternate sub-
scriber in the list, until the call is completed.
Redirect on Busy
will redirect calls (if Y) according to the Redirection Addresses if the primary sub-
scriber device is busy.
Redirect on Out of Order
Redirect on Busy Y/N N
Redirect on Out of Order Y/N N
Connection Priority 0–9 0
1st, 2nd,etc. Path Configured Y/N N
RLP n/a 0
Port Physical port: 0–3 1
Logica l po r t: 8–63 10
Redi rection Address 0,1 ,etc. valid address none
Table 10-3 SVC Subscriber Parameters
Parameter Valid Values Default Value