Cabletron Systems 1800 NetView Parameters

4-6 Smart Switch 1800 4. 0 User Guide , Rev 0 1
Alarm Autocall Timer
specifies the frequency with which th e SmartSwitch will attempt to e stablish an alarm
connection with its Primary Alarm Output ID during initial call setup or after the pre-
vious alarm connection is cleared.
Alarm Max Retries
is the number of times the SmartSwitch will attempt to establish an alarm connection
with its Primary Alarm Output ID during initial call setup or after the previous alarm
connection is cleared.
If the value specified is greater than 0, the Alarm Autocall Timer will be used until the
maximum retry value is reached. If the connection is still not established, a retry will
be made once eve r y hour.
NetView Parameters
1Up to 10 characters can be entered, but only t he first 8 will be recognized by NetView.
2Be aware that some NVMTs are larger than 265 bytes, so you may want to set the value
higher.
3In mu ltiple s of 4.
4Must be less th an the value for T1 to ensure that the remote link station will receive the
delayed acknowledgment before T1 expires.
Name
is the VTAM PU name that will identify the SmartSwitch 1800 as a NetView Service
Point.
Local Subscriber ID
is a subscriber address for the lo cal end of an LLC2 sessio n establis he d for a NetView
connection. An LLC2 H ost r ecord (described in Chapter 9) must be created, with
Table 4-2 NetView Parameters
Param eter Val id Values Default Va l ue
Name up to 8 characters 1none
Local Subscriber ID 0–15 characters none
Remote Subscrib er ID 0–15 characters none
Maximum Bytes pe r Frame 25–4105 265 2
Local SAP Ad dress 0–fc (hex) 304
Local MAC Address 0–fffff ffffff f 0000000 00000
IDBLK 0–fff 000
IDNUM 0–fffff 000 00
T1 0–250 (x 100 msec) 10 (1 sec)
T2 100–500 0 (msec) 4100
Ti 1–50 (sec) 30
N3 1–127 1
Tw 1–127 1
N2 0–255 8
Priorit y 0–9 0
Bandwidth Allocation Group 1–1 6 1