8-20 Smart Switch 1800 4. 0 User Guide , Rev 0 1
Configuring Subscriber IDs
This operation configures the called and calling addresses that will be used in call
setup. To complete the connection, the software must recognize where the call is
coming from (calling address) and where it is going (called address).
To display a list of current Subscriber IDs (addresses), press [A] at the Con nec tio ns an d
Routing Paths Menu (or [A], [D], [A] from the Main Menu).
To add or change a Subscriber ID, press [B] at the Co nnecti ons an d Rout ing Path s
Menu. When prompted, enter a Subscriber ID of up to 15 digits. (ID conventions are
descri be d on p age 8- 22.)
Figure 8-6 Typi c al SVC Sub scrib er Scre en
[A],[D],[B]
from Main Menu
If configuring an ID that w ill be a Source Subscriber on an IP (over X.25)
Interface (described in Chapter 14), accept the default values for all param-
eters after Subscriber Name, and do not co nfigure any Routi ng Pat h. If con-
figuring an ID that will be a Destination Subscriber on an IP ( o v er X. 25)
Interface, accept the default values for all parameters after Subscriber
Name, excep t 1st Routing Path, which m us t be conf igur ed as the no de and
physical X.25 port that will be used as the interface.
Pressing [G] will display routing paths, which link the subscriber with one or more
ports. Pressin g [H] will display the addresses used for call redirection. (These
addresses are valid only if Y is specified for one or more of items C, D, and E on the
first screen.) Parameters for all three screens are described following Table 8-3.
Node Name=nodexyz
SVC Subsc ri be r Main tenance
* Subscriber ID 0100012345
A Subscribe r Nam e sub1
B Routing Al g ori t hm 0, Round Robi n
C Systematic Redirection N
D Redirect on Busy N
E Redirect on Out of Order N
F Connect ion Priority 0
G Routing Paths
H Redirection Ad dresse s
Option: