20-26 Sm artSwit ch 1800 4.0 U ser Gui de, Rev 01
IP Status Displays

IP Rout ing Ta ble

To display a list of active IP routes, press [A] at the IP Status Displays Menu (or [C],
[F], [G], [A] from the Main Menu).
Information in this Display:
●Destination – Destination IP address.
●Gateway – IP address of router that provides access to the destination device.
(This corres p on ds to the Router parameter in static IP Routes. (See page 14-15.)
●Ref – (Reference) Internal count of the number of places the route is currently
being used in the SmartSwitch 1800 software. The route cannot be removed if
this count is greater than zero.
●Use – Number of times the route was used to send a packet.
●Flags:C = Route is on a LAN interface.
G = Route is via a remote gateway (hop count is greater than zero).
H = Route is a Host route.
S = Route is a static route.
U = Route is operational.
●Intf – (Interface) Identifier used in the IP Route Display. Each entry is the
interface number preceded by the interface type, which is one of these:
fr Frame relay xX.25 en Ethernet
tr Token Ring lo Loop back
●Netmask – Network m ask, us e d durin g rou t ing to de t ermin e the po rtion o f the
address associated with the network.
Point-to-point frame relay IP connections will display a Netmask of
255.255.255.255, which is the default Destination Mask value (see
page 14 -15) fo r Host I P route s. The Netmask configured on the IP
interface (see page 14-9) is used by RIP for route summarization.
Each entry is two lines on the screen, with the Netmask on the second line,
under the associated Destination.

ARP Table

To display a list of active ARP (Address Resolution Protocol) table entries, press [B]
at the IP Status Displays Menu (or [C], [F], [G], [B] from the Main Menu).
Information in this Display:
●IP Addr e s s – Address of corresponding IP Interface.
●MAC Address – MAC address to which each IP address maps.
●AgeOut Timer – Time (in seconds) until the address will be removed from the
table if no traffic is received from that addres s. The addre ss is added to the tab le
after the SmartSwitch sends an ARP request for an IP address and receives a
MAC address in re sponse. The timer is reset if an IP fr ame is received from the
either the IP or MAC address.