Epson Z8255NL Indicator is lit or flashing red, Status Cause Remedy or Status Internal Error

Problem Solving 97

EIndicates the projection lamps status.

Flashes green while Shutter or Blank is activated.

Refer to the following table to see what the indicators mean and how to remedy problems that they indicate.

If all indicators are off, check that the power cable is connected correctly and that the power is being supplied normally. Sometimes, when the power cable is unplugged, the t indicator remains lit for a short period, but this is not a malfunction.

t Indicator is lit or flashing red

: Lit

: Flashing:

: Off

Status	Cause	Remedy or Status
	Internal Error	Stop using the projector, disconnect the power cable from the electrical outlet, and contact Epson. s p.114

Fan Error	Stop using the projector, disconnect the power cable from the electrical outlet, and contact Epson. s p.114
Sensor Error
Cool System Error
High Temp Error	The lamps turn off automatically and projection stops. Wait for about five minutes. After about five minutes
(overheating)	the projector switches to standby mode, so check the following two points.
	• Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall.
	• If the air filter is clogged, clean or replace it. s p.116, p.122
	If the error continues after checking the points above, stop using the projector, disconnect the power cable
	from the electrical outlet, and contact Epson. s p.114
	When using at an altitude of 4621 ft (1500 m) or more, set High Altitude Mode to On. s p.67
	Set Direction to Pointing Down, Pointing Up, Angled Up, or Angled Down when the projector is installed
	in a direction which is not horizontal. s p.67