Epson Z8455WUNL, Z8255NL, Z8350WNL, Z8150NL, Z8250NL 108, Is Control Panel Lock set to Full Lock?

Problem Solving 108

Check	Remedy
Do the indicators turn on and off when the power cable is	There is probably a poor contact in the power cable, or the power cable may be defective. Reinsert the
touched?	power cable. If this does not solve the problem, stop using the projector, disconnect the power cable
	from the electrical outlet, and contact Epson. s p.114
Is Control Panel Lock set to Full Lock?	Press the [t] button on the remote control. If you do not want to use Control Panel Lock, change the
	setting to Off. s Settings Menu - Control Panel Lock p.65
Is the correct setting for the remote receiver selected?	Check the Remote Receiver from the configuration menu. s Settings Menu - Remote Receiver p.65
Was the power cable plugged back in or was the breaker	Even when Direct Power On is set to On, the power may not turn back on. Press the [t] button to turn
turned on immediately after Direct Power Off?	the power back on in these instances.
Is the ID switch on the side of the remote control set to On?	When the switch is set to On, you can use the remote control to operate only a projector with a matching
	ID. Set ID switch to Off. s p.175
Are the lamp cover and lamps installed correctly?	If the lamp or lamp cover is installed incorrectly, the projector cannot be turned on. Check how it is
	installed. s p.119