Epson Z8450WUNL, Z8455WUNL, Z8255NL Using the Mail Notification Function to Report Problems, 131

Using the Mail Notification Function to Report Problems 131

Using the Mail Notification Function to Report Problems

By setting the Mail Notification function from the projector's Configuration Menu, notification messages will be sent to the preset email addresses when a problem or warning occurs with a projector. This will enable the operator to be notified of problems with projectors even at locations away from the projectors. s Network Menu - Administrator Settings - Mail Notification p.84

q	• Up to three notification destinations (Addresses) can be recorded, and
	notification messages can be sent to all three destinations at once.
	• If a projector develops a critical problem and suddenly stops working, it
	may not be able to send a message notifying an operator of the problem.
	• Monitoring is possible if Standby Mode is set to Communication On from
	the Extended menu of the projector's Configuration Menu, even if the
	projector is in standby state (when the power is off). s p.67

Reading Problem Mail Notification Function

When the Mail Notification function is set to On and a problem/warning occurs in the projector, the following e-mail is sent.

Sender: Email Address 1

Subject: EPSON Projector

Line 1: The name of the projector where the problem has occurred

Line 2: The IP address set for the projector where the problem has occurred.

Line 3 and on: Details of the problem

The details of the problem are listed line by line. The following table shows the details that are given in the message for each item. To deal with problems/warnings, see "Reading the Indicators" s p.96

Message	Cause (Problems/Warnings)
Clean Air Filter	Air Filter Notice
Fan related error	Fan Error
High-speed cooling in progress	High Temp Warning
Internal error	Internal Error
Internal temperature error	High Temp Error
	(Overheating)
Lamp cover is open.	Lamp Cover Open
Lamp out	Lamp Error
Lamp replacement notification	Replace Lamp
Lamp timer failure	Lamp Failure
Low Air Flow	Low Air Flow
Low Air Flow Error	Filter Airflow Error
No-signal	No Signal
	No Signal is input to the projector.
	Check the connection status or check
	that the power for the signal source is
	turned on.
Power Err. (Ballast)	Power Err. (Ballast)
Sensor error	Sensor Error

A (+) or (-) appears at the start of the message. (+): A projector problem has occurred

(-): A projector problem has been dealt with