Epson Z8350WNL, Z8455WUNL, Z8255NL, Z8150NL, Z8250NL, Z8450WUNL manual Keystone, 164

Adjusting the Projected Image

D To adjust the shape, use the [h] button on the remote control or the [w/ ], [v/ ], [</ ], and [>/ ] buttons on the control panel.

If the triangle in the direction you are adjusting the shape turns gray, as shown in the screenshot below, you cannot adjust the shape any further in that direction.

164

E Repeat steps 3 and 4 as needed to adjust any remaining corners.

F When you are done, press the [Esc] button to exit the correction menu.

Because the correction method was changed to Quick Corner from Geometric Correction in the configuration menu, when [w/ ], [v/ ], [</ ], and [>/ ] buttons are pressed later, the screen for selecting the corner in step 2 is displayed. Change Geometric Correction from the configuration menu to H/V-Keystoneif you want to correct H/V-Keystone when pressing the [w/ ], [v/ ], [</ ], and [>/ ] buttons on the control panel. s p.65

q If the [Esc] button is held down for about two seconds while correcting with Quick Corner, the confirm default reset screen is displayed.

Select "Yes" to reset the result of Quick Corner corrections.

H/V-Keystone

Procedure

Press the [w/ ], [v/ ], [</ ], and [>/ ] buttons on the control panel to adjust keystone settings in the horizontal and vertical di- rections independently.

q This adjustment can also be made from Geometric Correction - H/V-Keystoneon the Settings menu. s p.65