Epson Z8350WNL, Z8455WUNL Adjusting the Position of the Projected Image, Point Correction, 176

Settings for Multiple Projectors 176

q The remote control ID setting is saved in the remote control. Even if the remote control batteries are removed to replace them and so on, the stored ID setting is retained. However, if the batteries are left out for a long time, it is reset to the default value (ID0).

Adjusting the Position of the Projected Image

Adjust the position of the projected image, starting from the adjustments that have larger corrections. For the best results, use physical adjustments (moving the projector’s position, optical zoom, and lens shift) as much as possible to minimize the amount of digital correction (Quick Corner, Point Correction, H/V keystone, etc.) needed to correct your images.

1.Projector’s position (angle) s p.150

2.Image zoom s p.160

3.Lens shift/Zoom s p.159

4.Geometric Correction

•Quick Corner s p.162

•Point Correction s p.176

q	• We recommend setting the focus, zoom, and lens shift at least 30 minutes
	after you start the projection, because images are not stable right after
	turning on the projector.
	• The Test Pattern can be displayed to adjust the projection status without
	connecting video equipment. s p.157
	• When projecting from multiple projectors, correction is easier if images are
	displayed as is (aspect ratio and image resolution are maintained) and
	without being enlarged or reduced in size.]
	• We recommend projecting from the center of the lens when possible. As you
	get to the edges, the lens gets thinner which can cause distortion and affect
	the quality of the blend.

Point Correction

Corrects slight distortion which occurs partially, or adjusts the screen position in an overlapping area when projecting from multiple projectors.

A grid is placed on top of the projected image and you can move the points of intersection on the grid left, right, up, or down to correct distortion.

Procedure

A During projection, press the [Menu] button. Select Settings menu - "Geometric Correction" and then press the [Enter] button. s "Using the Configuration Menu" p.55

Remote Control