Epson Z8350WNL, Z8455WUNL, Z8255NL Sub Menu Function Operation, Standby Mode, Air Filter Notice

Extended Menu 68

Sub Menu	Function
Operation	Direct Power On: You can set whether or not (On/Off) to enable Direct Power On.
	Be careful when this item is set to On because this unit turns on at the time of power recovery with this unit plugged-in to an outlet.
	Sleep Mode: When set to On, this automatically stops projection when no image signal is being input and no operations are carried
	out.
	Sleep Mode Timer: When Sleep Mode is set to On, you can set the time before the projector automatically turns off within a range
	of 1 to 30 minutes.
	Shutter Button: Select an operation to be done when the [Shutter] button is pressed. When Electric Shutter is selected, the
	electric shutter opens/closes. s p.39 When Blank is selected, this turns off the video temporarily.
	Shutter Timer: When set to On, this turns off the power automatically 30 minutes after the electric shutter is closed.
	Shutter Timer is set to On at the time of purchase. (When Shutter Timer and Sleep Mode are set to On at the same time, Sleep
	Mode has priority.)
	High Altitude Mode: Set to On when using the projector above an altitude of 4921 ft (1500 m).
	BNC Sync Termination: Set the termination for the signal from the BNC input port. This should usually be set to Off. Set to On
	when analog (75Ω) termination such as for switchers is necessary.
	Remote Control Type: You can select Normal or Simple depending on the type of remote control.
	Set this item to Normal to use the remote control provided with the projector. When Simple is selected, you can use the remote
	control provided with other Epson projectors to operate this projector. This is useful if you want to use a remote control that you
	are already familiar with to operate the projector.
	However, you cannot use the remote control provided with this projector if this is set to Simple. Make sure that the setting is
	correct because, if the projector is mounted on the ceiling or somewhere hard to reach, changing it back to Normal may be
	difficult. Additionally, you cannot use the functions that are not equipped with this projector or the remote control which you use.
	Beep: When this is set to On, the confirmation buzzer beeps to notify you that the power turns on or off, the electric shutter opens
	or closes, or the cooling down is finished.
Standby Mode	You can use the functions that monitor and control the status of the projector over the network even when the projector is in
	standby mode if this is set to Communication On.
Air Filter Notice	You can set whether or not (On/Off) to enable the Air Filter Notice. When this is set to On and a clog in the air filter is detected, the
	message is displayed on the screen.