set server group load-balance

Enables or disables load balancing among the RADIUS servers in a server group.

Syntax: set server group group-nameload-balance {enable disable}

group-name

Server group name of up to 32 characters.

load-balance

Enables or disables load balancing of authentication requests among

enable disable

the servers in the group.

Defaults: Load balancing is disabled by default.

Access: Enabled.

Usage: You can optionally enable load balancing after assigning the server group members. If you configure load balancing, MSS sends each AAA request to a separate server, starting with the first one on the list and skipping unresponsive servers. If no server in the group responds, MSS moves to the next method configured with set authentication and set accounting.

In contrast, if load balancing is not configured, MSS always begins with the first server in the list and sends unfulfilled requests to each subsequent server in the group before moving on to the next configured AAA method.

Examples: To enable load balancing between the members of server group shorebirds, type the following command:

DWS-1008# set server group shorebirds load-balance enable success: change accepted.

To disable load balancing between shorebirds server group members, type the following command:

DWS-1008# set server group shorebirds load-balance disable success: change accepted.

See Also:

clear server group

clear radius server

set server group

show aaa

D-Link DWS-1008 CLI Manual

239

Page 242
Image 242
D-Link dws-1008 manual Set server group load-balance, Group-name Server group name of up to 32 characters, Enable disable