Defaults: The default interval is 60 seconds.

Access: Enabled.

Examples: The following command changes the power ramp interval for radios in radio profile rp2 to 120 seconds:

DWS-1008# set radio-profile rp2 auto-tunepower-ramp-interval 120 success: change accepted.

See Also:

set {ap dap} radio auto-tune max-power

set radio-profile auto-tune power-config

set radio-profile auto-tune power-interval

set radio-profile auto-tune power-lockdown

show radio-profile

set radio-profile beacon-interval

Changes the rate at which each DWL-8220AP radio in a radio profile advertises its service set identifier (SSID).

Syntax: set radio-profile name beacon-interval interval

name

Radio profile name.

interval

Number of milliseconds (ms) between beacons. You can specify from 25 ms to

 

8191 ms.

Defaults: The beacon interval for DWL-8220AP radios is 100 ms by default.

Access: Enabled.

Usage: You must disable all radios that are using a radio profile before you can change parameters in the profile. Use the set radio-profile mode command.

Examples: The following command changes the beacon interval for radio profile rp1 to 200 ms:

DWS-1008# set radio-profile rp1 beacon-interval 200 success: change accepted.

See Also:

set radio-profile mode

show radio-profile

D-Link DWS-1008 CLI Manual

341

Page 344
Image 344
D-Link dws-1008 manual Set radio-profile beacon-interval, Defaults The default interval is 60 seconds