D-Link dws-1008 manual Set rfdetect log, Set rfdetect signature

See Also:

•clear rfdetect ignore

•show rfdetect ignore

set rfdetect log

Disables or reenables generation of log messages when rogues are detected or when they disappear.

Syntax: set rfdetect log {enable disable}

enable	Enables logging of rogues.
disable	Disables logging of rogues.

Defaults: RF detection logging is enabled by default.

Access: Enabled.

Usage: The log messages for rogues are generated only on the seed and appear only in the seed’s log message buffer. Use the show log buffer command to display the messages in the seed switch’s log message buffer.

Examples: The following command enables RF detection logging for the Mobility Domain managed by this seed switch:

DWS-1008# set rfdetect log enable success: rfdetect logging is enabled.

See Also:

• show log buffer

set rfdetect signature

Enables AP signatures. An AP signature is a set of bits in a management frame sent by an AP that identifies that AP to MSS. If someone attempts to spoof management packets from a D-Link AP, MSS can detect the spoof attempt.

Syntax: set rfdetect signature {enable disable}

enable	Enables AP signatures.
disable	Disables AP signatures.

Defaults: AP signatures are disabled by default.

Access: Enabled.

D-Link DWS-1008 CLI Manual 272