source-ip-addrIP address and wildcard mask of the network or host from which the packet

mask any is being sent. Specify both address and mask in dotted decimal notation. To match on any address, specify any or 0.0.0.0 255.255.255.255.

operator port Operand and port number(s) for matching TCP or UDP packets to the number

[port2]of the source or destination port on source-ip-addr or destination-ip-addr. Specify one of the following operands and the associated port:

eq—Packets are filtered for only port number.

gt—Packets are filtered for all ports that are greater than port number.

lt—Packets are filtered for all ports that are less than port number.

neq—Packets are filtered for all ports except port number.

range—Packets are filtered for ports in the range between port and port2. To specify a port range, enter two port numbers. Enter the lower port number first, followed by the higher port number.

destination-ip-addrIP address and wildcard mask of the network or host to which the packet is

mask any being sent. Specify both address and mask in dotted decimal notation. To match on any address, specify any or 0.0.0.0 255.255.255.255.

type icmp-typeFilters ICMP messages by type. Specify a value from through 255.

code icmp-codeFor ICMP messages filtered by type, additionally filters ICMP messages by code. Specify a value from 0 through 255. (For a list of ICMP message type

 

and code numbers, see www.iana.org/assignments/icmp-parameters.)

precedence

Filters packets by precedence level. Specify a value from 0 through 7:

precedence

 

 

0—routine precedence

 

1—priority precedence

 

2—immediate precedence

 

3—flash precedence

 

4—flash override precedence

 

5—critical precedence

 

6—internetwork control precedence

 

7—network control precedence

tos tos

Filters packets by type of service (TOS) level. Specify one of the following

 

values, or any sum of these values up to 15. For example, a tos value of 9

 

filters packets with the TOS levels minimum delay (8) and minimum monetary

 

cost (1).

 

8—minimum delay

 

4—maximum throughput

 

2—maximum reliability

 

1—minimum monetary cost

 

0—normal

D-Link DWS-1008 CLI Manual

477

Page 480
Image 480
D-Link dws-1008 manual Precedence, Tos tos