D-Link dws-1008 manual Set dap auto persistent, Set dap auto radiotype, Dap-num

set dap auto persistent

Converts a temporary AP configuration created by the AP configuration profile into a persistent AP configuration on the DWS-1008.

Syntax: set dap auto persistent [dap-num all]

dap-num	Converts the configuration of the Distributed AP that has the specified
	connection number into a permanent configuration.
all	Converts the configurations of all Auto-APs being managed by the switch
	into permanent configurations.

Defaults: None.

Access: Enabled.

Usage: To display the Distributed AP numbers assigned to Auto-APs, use the show dap status auto command.

Examples: The following command converts the configuration of Auto-AP 10 into a permanent configuration:

DWS-1008# set dap auto persistent 10 success: change accepted

See Also:

•set dap auto

•set dap auto mode

•set dap auto radiotype

set dap auto radiotype

Sets the radio type for single-AP radios that use the AP configuration profile.

Syntax: set dap auto [radiotype {11a 11b 11g}]

radiotype 11a 11b 11g Radio type:

• 11g - 802.11a

• 11a - 802.11b

• 11g - 802.11g

D-Link DWS-1008 CLI Manual 314