D-Link dws-1008 manual Set ap dap radio auto-tune max-power, Configuration template, Power-level

Defaults: All radios use the internal antenna by default.

Access: Enabled

Examples: The following command configures the 802.11b/g radio on Distributed AP 1 to use antenna model ANT1060:

DWS-1008# set dap 1 radio 1 antennatype ANT1060 success: change accepted.

See Also:

• show {ap dap} config

set {ap dap} radio auto-tune max-power

Sets the maximum power that RF Auto-Tuning can set on a radio.

Syntax: set {ap port-list dap {dap-num auto}} radio {1 2} auto-tune max-power power-level

ap port-list	List of ports connected to the DWL-8220AP access points on which to
	set the maximum power.
dap dap-num	Number of a Distributed AP on which to set the maximum power.
dap auto	Sets the maximum power for radios configured by the DWL-8220AP
	configuration template.
radio 1	Radio 1 of the DWL-8220AP.
radio 2	Radio 2 of the DWL-8220AP.
power-level	Maximum power setting RF Auto-Tuning can assign to the radio,
	expressed as the number of decibels in relation to 1 milliwatt (dBm). You
	can specify a value from 1 up to the maximum value allowed for the
	country of operation. The power-level can be a value from 1 to 20.

Defaults: The default maximum power setting that RF Auto-Tuning can set on a radio is the highest setting allowed for the country of operation or highest setting supported on the hardware, whichever is lower.

Access: Enabled.

D-Link DWS-1008 CLI Manual 327