D-Link dws-1008 manual Set dap auto, Syntax set dap auto Defaults None Access Enabled

set dap auto

Creates a profile for automatic configuration of Distributed APs.

Syntax: set dap auto

Defaults: None.

Access: Enabled.

The following Table lists the configurable profile parameters and their defaults.The only parameter that requires configuration is the profile mode. The profile is disabled by default. To use the profile to configure Distributed APs, you must enable the profile using the set dap auto mode enable command.

The profile uses the default radio profile by default. You can change the profile using the set dap auto radio radio-profilecommand. You can use set dap auto commands to change settings for the parameters listed in the following table. (The commands are listed in the “See Also” section.)

Parameter	Default Value
AP Parameters
bias	high
blink	disable
(Not shown in show dap config output)
force-image-download	None.
group (load balancing)	none
mode	disabled
persistent	none
upgrade-firmware	enable (YES)
(boot-download-enable)
Radio Parameters
radio num auto-tune max-power	default
radio num mode	enabled
radio num radio-profile	default
radiotype	11g (or 11b for country codes
	where 802.11g is not allowed)

D-Link DWS-1008 CLI Manual 312