D-Link dws-1008 manual Set service-profile wep key-index, Key-index num key value

Access: Enabled.

Usage: Before using this command, you must configure values for the WEP keys you plan to use. Use the set service-profile wep key-index command.

Examples: The following command configures service profile sp2 to use WEP key 4 for encrypting unicast traffic:

DWS-1008# set service-profile sp2 wep active-unicast-index 4 success: change accepted.

See Also:

•set service-profile wep active-multicast-index

•set service-profile wep key-index

•show service-profile

set service-profile wep key-index

Sets the value of one of four static Wired-Equivalent Privacy (WEP) keys for static WEP encryption.

Syntax: Syntax set service-profile name wep key-index num key value

name

key-index num key value

Service profile name.

WEP key index. You can enter a value from 1 through 4.

Hexadecimal value of the key. You can enter a 10-character ASCII string representing a 5-byte hexadecimal number or a 26-character ASCII string representing a 13-byte hexadecimal number. You can use numbers or letters. ASCII characters in the following ranges are supported:

•0 to 9

•A to F

•a to f

Defaults: By default, no static WEP keys are defined.

Access: Enabled.

Usage: MSS automatically enables static WEP when you define a WEP key. MSS continues to support dynamic WEP.

D-Link DWS-1008 CLI Manual 394