D-Link dws-1008 manual Set log mark, Severity level, Interval interval

set log mark

Configures MSS to generate mark messages at regular intervals.The mark messages indicate the current system time and date. D-Link can use the mark messages to determine the approximate time when a system restart or other event causing a system outage occurred.

Syntax: set log mark [enable disable] [severity level] [interval interval]

enable	Enables the mark messages.
disable	Disables the mark messages.
severity level	Log severity at which the messages are logged:
	• emergency
	• alert
	• critical
	• error
	• warning
	• notice
	• info
	• debug
interval interval	Interval at which MSS generates the mark messages. You can specify from
	1 to 2147483647 seconds.

Defaults: Mark messages are disabled by default. When they are enabled, MSS generates a message at the notice level once every 300 seconds by default.

Access: Enabled.

Examples: The following command enables mark messages:

DWS-1008# set log mark enable success: change accepted.

See Also:

• show log config

D-Link DWS-1008 CLI Manual 508