Examples: The following command creates an archive of the system-critical files and copies the archive directly to a TFTP server. The filename in this example includes a TFTP server IP address, so the archive is not stored locally on the switch.

DWS-1008# backup system tftp:/10.10.20.9/sysa_bak critical success: sent 28263 bytes in 0.324 seconds [ 87231 bytes/sec]

See Also:

dir

restore

clear boot backup-configuration

Clears the filename specified as the backup configuration file. In the event that MSS cannot read the configuration file at boot time, a backup configuration file is not used.

Syntax: clear boot backup-configuration

Defaults: None.

Access: Enabled.

Usage: You can create an archive located on a TFTP server or in the switch’s nonvolatile storage. If you specify a TFTP server as part of the filename, the archive is copied directly to the TFTP server and not stored locally on the switch.

Examples: The following command clears the name specified as the backup configuration file from the configuration of the switch:

DWS-1008# clear boot backup-configurationsuccess: Backup boot config filename was cleared.

See Also:

set boot backup-configuration

show boot

clear boot config

Resets to the factory default the configuration that MSS loads during a reboot.

Syntax: clear boot config

Defaults: None.

Access: Enabled.

D-Link DWS-1008 CLI Manual

288

Page 291
Image 291
D-Link dws-1008 Clear boot backup-configuration, Clear boot config, Syntax clear boot config Defaults None Access Enabled