D-Link dws-1008 manual Specifies the number of times the MSS Snmp engine will, Seconds

SNMPv2c with Informs

To configure a notification target for informs from SNMPv2c, use the following command:

Syntax: set snmp notify target target-num ip-addr [:udp-port-number]

v2c community-stringinform [profile profile-name] [retries num] [timeout num]

target-num	ID for the target. This ID is local to the switch and does not
	need to correspond to a value on the target itself. You
	can specify a number from 1 to 10.
ip-addr [:udp-port-number]	IP address of the server. You also can specify the UDP port
	number to send notifications to.
community-string	Community string.
profile profile-name	Notification profile this SNMP user will use to specify the
	notification types to send or drop.
retries num	Specifies the number of times the MSS SNMP engine will
	resend a notification that has not been acknowledged
	by the target. You can specify from 0 to 3 retries.
timeout num	Specifies the number of seconds MSS waits for
	acknowledgement of a notification. You can specify from 1 to
	5 seconds.
SNMPv2c with Traps

To configure a notification target for traps from SNMPv2c, use the following command:

Syntax: set snmp notify target target-num ip-addr [:udp-port-number] v2c community-string trap [profile profile-name]

target-num	ID for the target. This ID is local to the switch and does not
	need to correspond to a value on the target itself. You
	can specify a number from 1 to 10.
ip-addr [:udp-port-number]	IP address of the server. You also can specify the UDP port
	number to send notifications to.
community-string	Community string.
profile profile-name	Notification profile this SNMP user will use to specify the
	notification types to send or drop.

D-Link DWS-1008 CLI Manual 142