D-Link dws-1008 manual 144

set snmp protocol

Enables an SNMP protocol. MSS supports SNMPv1, SNMPv2c, and SNMPv3.

Syntax: set snmp protocol {v1 v2c usm all} {enable disable}

v1	SNMPv1
v2c	SNMPv2c
usm	SNMPv3 (with the user security model)
all	Enables all supported versions of SNMP.
enable	Enables the specified SNMP version(s).
disable	Disables the specified SNMP version(s).

Defaults: All SNMP versions are disabled by default.

Access: Enabled.

Usage: SNMP requires the switch’s system IP address to be set. SNMP will not work without the system IP address. You also must enable the SNMP service using the set ip snmp server command.

Examples: The following command enables all SNMP versions:

DWS-1008# set snmp protocol all enable success: change accepted.

See Also:

•set ip snmp server

•set snmp community

•set snmp notify target

•set snmp notify profile

•set snmp security

•set snmp usm

•show snmp status

set snmp security

Sets the minimum level of security MSS requires for SNMP message exchanges.

Syntax: set snmp security {unsecured authenticated encrypted auth-req-unsec-notify}

	unsecured	SNMP message exchanges are not secure. This is the only value
		supported for SNMPv1 and SNMPv2c.
	authenticated	SNMP message exchanges are authenticated but are not
		encrypted.
	encrypted	SNMP message exchanges are authenticated and encrypted.
	auth-req-unsecnotify	SNMP message exchanges are authenticated but are not
		encrypted, and notifications are neither authenticated nor
		encrypted.
D-Link DWS-1008 CLI Manual		144