set service-profile auth-dot1x

Disables or reenables 802.1X authentication of Wi-Fi Protected Access (WPA) clients by AP radios, when the WPA information element (IE) is enabled in the service profile that is mapped to the radio profile that the radios are using.

Syntax: set service-profile name auth-dot1x {enable disable}

name

Service profile name.

enable

Enables 802.1X authentication of WPA clients.

disable

Disables 802.1X authentication of WPA clients.

Defaults: When the WPA IE is enabled, 802.1X authentication of WPA clients is enabled by default. If the WPA IE is disabled, the auth-dot1x setting has no effect.

Access: Enabled.

Usage: This command does not disable dynamic WEP for non-WPA clients. To disable dynamic WEP for non-WPA clients, enable the WPA IE (if not already enabled) and disable the 40-bit WEP and 104-bit WEP cipher suites in the WPA IE, if they are not already disabled.

To use 802.1X authentication for WPA clients, you also must enable the WPA IE.

If you disable 802.1X authentication of WPA clients, the only method available for authenticating the clients is preshared key (PSK) authentication. To use this, you must enable PSK support and configure a passphrase or key.

Examples: The following command disables 802.1X authentication for WPA clients that use service profile wpa_clients:

DWS-1008# set service-profile wpa_clients auth-dot1x disable success: change accepted.

See Also:

set service-profile auth-psk

set service-profile psk-phrase

set service-profile wpa-ie

show service-profile

D-Link DWS-1008 CLI Manual

359

Page 362
Image 362
D-Link dws-1008 manual Set service-profile auth-dot1x, Syntax set service-profile name auth-dot1x enable disable