D-Link dws-1008 manual Show auto-tune attributes, Mp-num Dap-num

Output for show ap status terse and show dap status terse

Field	Description
Port	DWS-1008AP port number connected to the AP.
	Operational status flags for the AP.
Flg	For flag definitions, see the key in the command output.
	IP address of the AP. The address is assigned to the AP by a DHCP server.
IP Address	Note: This field is applicable only if the AP is configured on the DWS-1008 as
	a Distributed AP.
Model	AP model number.
MAC Address	MAC address of the AP.
	State, channel, and power information for radio 1:
Radio1	• The state can be D (disabled) or E (enabled).
	• The channel and power settings are shown as channel/power.
Radio2	State, channel, and power information for radio 2.
Uptime	Amount of time since the AP booted using this link.

show auto-tune attributes

Displays the current values of the RF attributes RF Auto-Tuning uses to decide whether to change channel or power settings.

Syntax show auto-tune attributes [ap mp-num[radio {1 2 all}]]

Syntax show auto-tune attributes [dap dap-num[radio {1 2 all}]]

mp-num

dap-num

radio1

radio2 radio all

Defaults Access

AP port connected to the AP access point for which to display RF attributes. Number of a Distributed AP for which to display RF attributes.

Shows RF attribute information for radio 1.

Shows RF attribute information for radio 2.

Shows RF attribute information for both radios.

None.

Enabled.

D-Link DWS-1008 CLI Manual 412