D-Link dws-1008 manual Set vlan name, Defaults Layer 2 restriction is disabled by default

Defaults: Layer 2 restriction is disabled by default.

Access: Enabled.

Usage:You can specify multiple addresses by listing them on the same command line or by entering multiple commands. To change a MAC address, use the clear security l2-restrictcommand to remove it, then use the set security l2-restrictcommand to add the correct address.

Restriction of client traffic does not begin until you enable the permitted MAC list. Use the mode enable option with this command.

Examples: The following command restricts Layer 2 forwarding of client data in VLAN abc_air to the default routers with MAC address aa:bb:cc:dd:ee:ff and 11:22:33:44:55:66:

DWS-1008#set security l2-restrict vlan abc_air mode enable permit-mac aa:bb:cc:dd:ee:ff 11:22:33:44:55:66

success: change accepted.

See Also:

•clear security l2-restrict

•clear security l2-restrict counters

•show security l2-restrict

set vlan name

Creates a VLAN and assigns a number and name to it.

Syntax: set vlan vlan-numname name

vlan-numVLAN number. You can specify a number from 2 through 4093.

name String up to 16 alphabetic characters long.

Defaults: VLAN 1 is named default by default. No other VLANs have default names.

Access: Enabled.

Usage: You must assign a name to a VLAN (other than the default VLAN) before you can add ports to the VLAN.

D-Link recommends that you do not use the name default. This name is already used for VLAN

1.D-link also recommends that you do not rename the default VLAN. You cannot use a number as the first character in the VLAN name. D-Link recommends that you do not use the same name with different capitalizations for VLANs. For example, do not configure two separate VLANs with the names red and RED.

D-Link DWS-1008 CLI Manual 66