D-Link dws-1008 manual Set service-profile static-cos, Enables static CoS on the service profile

set service-profile static-cos

Enables or disables static CoS on a service profile. Static CoS assigns the same CoS level to all traffic on the service profile’s SSID, regardless of 802.1p or DSCP markings in the packets themselves, and regardless of any ACLs that mark CoS. This option provides a simple way to configure an SSID for priority traffic such as VoIP traffic.

When static CoS is enabled, the standard MSS prioritization mechanism is not used. Instead, the AP sets CoS as follows:

•For traffic from the AP to clients, the AP places the traffic into the forwarding queue that corresponds to the CoS level configured on the service profile. For example, if the static CoS level is set to 7, the AP radio places client traffic in its Voice queue.

•For traffic from clients to the network, the AP marks the DSCP value in the IP headers of the tunnel packets used to carry the user data from the AP to the DWS-1008.

Syntax: set service-profile name static-cos {enable disable}

name	Service profile name.
enable	Enables static CoS on the service profile.
disable	Disables static CoS on the service profile.

Defaults: Static CoS is disabled by default.

Access: Enabled.

Usage: The CoS level is specified by the set service-profile cos command.

Examples: The following command enables static CoS on service profile sp1:

DWS-1008# set service-profile sp1 static-cos enable success: change accepted.

See Also:

•set service-profile cos

•show service-profile

D-Link DWS-1008 CLI Manual 385