D-Link dws-1008 manual Set igmp querier, Set igmp receiver, Show igmp querier

Adds the port to the list of static multicast receiver ports. Removes the port from the list of static multicast receiver ports.

Network port list. MSS adds the specified ports to the list of static multicast receiver ports.

Disables the pseudo-querier.

VLAN name or number. If you do not specify a VLAN, the pseudo-querier is enabled or disabled on all VLANs.

Enables the pseudo-querier.

set igmp querier

Enables or disables the IGMP pseudo-querier on a DWS-1008 switch, on one VLAN or all VLANs.

Syntax: set igmp querier {enable disable} [vlan vlan-id] enable

disable vlan vlan-id

Defaults: The pseudo-querier is disabled on all VLANs by default.

Access: Enabled.

Usage: D-Link recommends that you use the pseudo-querier only when the VLAN contains local multicast traffic sources and no multicast router is servicing the subnet.

Examples: The following example enables the pseudo-querier on the orange VLAN:

DWS-1008# set igmp querier enable vlan orange success: change accepted.

See Also:

• show igmp querier

set igmp receiver

Adds or removes a network port in the list of ports on which a switch forwards traffic to multicast receivers. Static multicast receiver ports are immediately added to or removed from the list of receiver ports and do not age out.

Syntax: set igmp receiver port port-list{enable disable} port port-list

enable disable

Defaults: By default, no ports are static multicast receiver ports.

Access: Enabled.

D-Link DWS-1008 CLI Manual 458