Field

Description

 

 

Gateway

Next-hop router for reaching the route destination.

Note: This field applies only to static routes.

 

 

 

 

Destination VLAN, protocol type, and IP address of the route. Because direct routes are for

 

local interfaces, a destination IP address is not listed. The destination for the IP multicast

 

route is MULTICAST.

VLAN:Interface

For static routes, the value Down means the switch does not have an interface to the

 

destination’s next-hop router. To provide an interface, configure an IP interface that is in the

 

same IP subnet as the next-hop router. The IP interface must be on a VLAN containing the

 

port that is attached to the default router.

 

 

show ip telnet

Displays information about the Telnet management port.

Syntax: show ip telnet

Defaults: None.

Access: All.

Examples: The following command shows the status and port number for the Telnet management interface to the switch:

DWS-1008> show ip telnet

Server Status

Port

----------------------------------

Enabled

23

The table below describes the fields in this display.

Field

Description

 

 

Server Status

State of the HTTPS server:

 

• Enabled

 

• Disabled

 

 

Port

TCP port number on which the switch listens for

 

Telnet management traffic.

 

 

See Also:

clear ip telnet

set ip https server

set ip telnet

set ip telnet server

show ip https

D-Link DWS-1008 CLI Manual

161

Page 164
Image 164
D-Link dws-1008 manual Show ip telnet, Displays information about the Telnet management port