name

Service profile name.

enable

Enables radios to leave a roamed user on the same VLAN instead of reassigning

 

the VLAN.

disable

Configures radios to reassign a roamed user’s VLAN.

Defaults: This option is disabled by default.

Access: Enabled.

Usage: Even when this option is enabled, the DWS-1008 to which a user roams (the roamed-to switch) can reassign the VLAN in any of the following cases:

A location policy on the local switch reassigns the VLAN.

The user is configured in the switch’s local database and the VLAN-Name attribute is set on the user or on a user group the user is in.

The access rule on the roamed-to switch uses RADIUS, and the VLAN-Name attribute is set on the RADIUS server.

Examples: The following command enables the keep-initial-vlan option on service profile sp3:

DWS-1008# set service-profile sp3 keep-initial-vlan enable success: change accepted.

See Also:

• show service-profile

set service-profile long-retry-count

Changes the long retry threshold for a service profile. The long retry threshold specifies the number of times a radio can send a long unicast frame without receiving an acknowledgment. A long unicast frame is a frame that is equal to or longer than the frag-threshold.

Syntax: set service-profile name long-retry-count threshold

name

Service profile name.

threshold Number of times the radio can send the same long unicast frame.You can enter a value from 1 through 15.

Defaults: The default long unicast retry threshold is 5 attempts.

D-Link DWS-1008 CLI Manual

370

Page 373
Image 373
D-Link dws-1008 manual Set service-profile long-retry-count, Configures radios to reassign a roamed user’s Vlan