Adds the port to the list of static multicast router ports. Removes the port from the list of static multicast router ports.
Port list. MSS adds or removes the specified ports in the list of static multicast router ports.
VLAN name or number. If you do not specify a VLAN, the timer change applies to all VLANs.
Amount of time (in tenths of a second) that the switch waits for a response to a group-specific query after receiving a leave message for that group, before removing the receiver that sent the leave message from the list of receivers for the group. If there are no more receivers for the group, the switch also sends a leave message for the group to multicast routers. You can specify a value from 1 through 65,535.

set igmp lmqi

Changes the IGMP last member query interval timer on one VLAN or all VLANs on a switch.

Syntax: set igmp lmqi tenth-seconds[vlan vlan-id] lmqi tenth-seconds

vlan vlan-id

Defaults: The default last member query interval is 10 tenths of a second (1 second).

Access: Enabled.

Examples: The following command changes the last member query interval on VLAN orange to

5 tenths of a second:

DWS-1008# set igmp lmqi 5 vlan orange success: change accepted.

See Also:

set igmp oqi

set igmp qi

set igmp mrouter

set igmp mrouter

Adds or removes a port in a switch’s list of ports on which it forwards traffic to multicast routers. Static multicast ports are immediately added to or removed from the list of router ports and do not age out.

Syntax: set igmp mrouter port port-list{enable disable} port port-list

enable disable

D-Link DWS-1008 CLI Manual

452

Page 455
Image 455
D-Link dws-1008 manual Set igmp lmqi, Set igmp oqi Set igmp qi Set igmp mrouter, Link DWS-1008 CLI Manual 452