D-Link dws-1008 manual Change, Syntax change

change

Changes parameters in the currently active boot profile.

Syntax: change

Defaults: The default boot type is c (compact flash). The default filename is default. The default flags setting is 0x00000000 (all flags disabled) and the default options list is run=nos;boot=0. The default device setting is the boot partition specified by the most recent set boot partition command typed at the Enabled level of the CLI, or boot 0 if the command has never been typed.

Access: Boot prompt.

Usage: After you type the change command, the system interactively displays the current setting of each parameter and prompts you for the new setting. When prompted, type the new setting, press Enter to accept the current setting, or type . (period) to change the setting to its default value. To back up to the previous parameter, type - (hyphen).

Examples: The following command enters the configuration mode for the currently active boot profile, changes the device to boot1, and leaves the other parameters with their current settings:

boot> change

Changing the default configuration is not recommended.

Are you sure that you want to proceed? (y/n)y

BOOT TYPE:	[c]
DEVICE:	[boot0:]boot1
FILENAME:	[default]
FLAGS:	[0x00000000]
OPTIONS:	[run=nos;boot=0]

The following command enters the configuration mode for the currently active boot profile and configures the switch to boot using a TFTP server:

boot> change

Changing the default configuration is not recommended.

Are you sure that you want to proceed? (y/n)y

	BOOT TYPE:	[c]> n
	DEVICE:	[boot0:]> emac1
	FILENAME:	[default]> bootfile
	HOST IP:	[0.0.0.0]> 172.16.0.1
	LOCAL IP:	[0.0.0.0]> 172.16.0.21
	GATEWAY IP:	[0.0.0.0]> 172.16.0.20
	IP MASK:	[0.0.0.0]> 255.255.255.0
	FLAGS:	[0x00000000]>
	OPTIONS:	[run=nos;boot=0]>
D-Link DWS-1008 CLI Manual		516