D-Link dws-1008 manual Set port trap, Enable, Disable

Examples: The following command sets the port speed on ports 1, 3 through 5, and 8 to 10 Mbps and sets the operating mode to full-duplex:

DWS-1008#set port speed 1,3-5,8 10

set port trap

Enables or disables Simple Network Management Protocol (SNMP) linkup and linkdown traps on an individual port.

Syntax: set port trap port-list{enable disable}

port-list	List of physical ports.
enable	Enables the Telnet server.
disable	Disables the Telnet server.

Defaults: SNMP linkup and linkdown traps are disabled by default.

Access: Enabled.

Usage: The set port trap command overrides the global setting of the set snmp trap command.

The set port type command does not affect the global trap information displayed by the show snmp configuration command. For example, if you globally enable linkup and linkdown traps but then disable the traps on a single port, the show snmp configuration command still indicates that the traps are globally enabled.

Examples: The following command enables SNMP linkup and linkdown traps on ports 5 and 6:

DWS-1008#set port trap 5-6 enable

See Also:

•set ip snmp server

•set snmp community

•set snmp trap

•set snmp trap receiver

D-Link DWS-1008 CLI Manual 50