D-Link dws-1008 Set port type wired-auth, Port-list tag-list Num last-resort, None web-portal

set port type wired-auth

Configures an DWS-1008 port for a wired authentication user.

Syntax: set port type wired-auth port-list[tag tag-list] [max-sessions num] [auth-fall-thru {last-resort none web-portal}]

port-list tag-list

num last-resort

none web-portal

List of physical ports.

One or more numbers between 1 and 4094 that subdivide a wired authentication port into virtual ports.

Maximum number of simultaneous user sessions supported.

Automatically authenticates the user without requiring a user name and password.

Denies authentication and prohibits the user from accessing the network over this port.

Serves the user a web page from the DWS-1008’s nonvolatile storage for a secure login to the network.

Defaults: The default tag-list is null (no tag values). The default number of sessions is 1. The default fallthru authentication type is none.

Access: Enabled.

Usage: You cannot set a port’s type if the port is a member of a port VLAN. To remove a port from a VLAN, use the clear vlan command. To reset a port as a network port, use the clear port type command.

When you change port type, MSS applies default settings appropriate for the port type. The following Table lists the default settings that MSS applies when you set a port’s type to wired-auth.

Wired Authentication Port Defaults:

Port Parameter	Setting
	Removed from all VLANs. You cannot assign an AP access port to a
VLAN Membership	VLAN. MSS automatically assigns AP access ports to VLANs based on
	user traffic.
Spanning Tree Protocol	Not applicable.
(STP)
802.1x	Uses authentication parameters configured for users.
Port Groups	Not applicable.
IGMP Snooping	Enabled as users are authenticated and join VLANs.
Maximum user	One (1)
sessions
Fallthru Auth type	None

D-Link DWS-1008 CLI Manual 53