DWS-1008#set snmp notify profile snmpprof_rfdetect send

RFDetectSpoofedSsidAPTraps success: change accepted.

DWS-1008#set snmp notify profile snmpprof_rfdetect send

RFDetectUnAuthorizedAPTraps success: change accepted.

DWS-1008#set snmp notify profile snmpprof_rfdetect send

RFDetectUnAuthorizedOuiTraps success: change accepted.

DWS-1008#set snmp notify profile snmpprof_rfdetect send

RFDetectUnAuthorizedSsidTraps

success: change accepted.

set snmp notify target

Configures a notification target for notifications from SNMP.

A notification target is a remote device to which MSS sends SNMP notifications.You can configure the MSS SNMP engine to send confirmed notifications (informs) or unconfirmed notifications (traps). Some of the command options differ depending on the SNMP version and the type of notification you specify. You can configure up to 10 notification targets.

SNMPv3 with Informs

To configure a notification target for informs from SNMPv3, use the following command:

Syntax: set snmp notify target target-numip-addr[:udp-port-number] usm inform user username snmp-engine-id {ip hex hex-string} [profile profile-name] [security {unsecured authenticated encrypted}] [retries num] [timeout num]

target-num

ID for the target. This ID is local to the switch and does not need to

 

correspond to a value on the target itself. You can specify a number

 

from 1 to 10.

ip-addr[:udp-port-number]IP address of the server. You also can specify the UDP port number

 

to send notifications to.

username

USM username. This option is applicable only when the SNMP

 

version is usm. If the user will send informs rather than traps,

 

you also must specify the snmp-engine-id of the target.

D-Link DWS-1008 CLI Manual

107

Page 110
Image 110
D-Link dws-1008 manual Set snmp notify target, SNMPv3 with Informs, Username