Forces all wired authentication ports running 802.1X to unconditionally accept all 802.1X authentication attempts with an EAP Success message (ForceAuth).
Allows all wired authentication ports running 802.1X to use the authentication specified per port by the set dot1X port-controlcommand.

clear dot1x tx-period

Resets to the default setting the number of seconds that must elapse before the switch retransmits an EAP over LAN (EAPoL) packet.

Syntax: clear dot1x tx-period

Defaults: The default is 5 seconds.

Access: Enabled.

Examples: Type the following command to reset the EAPoL retransmission time:

DWS-1008# clear dot1x tx-periodsuccess: change accepted

See Also:

set dot1x tx-period

show dot1x

set dot1x authcontrol

Provides a global override mechanism for 802.1X authentication configuration on wired authentication ports.

Syntax: set dot1x authcontrol {enable disable} enable

disable

Defaults: By default, authentication control for individual wired authentication is enabled.

Access: Enabled.

Usage: This command applies only to wired authentication ports.

Examples: To enable per-port 802.1X authentication on wired authentication ports, type the following command:

DWS-1008# set dot1x authcontrol enable success: dot1x authcontrol enabled.

D-Link DWS-1008 CLI Manual

245

Page 248
Image 248
D-Link dws-1008 manual Clear dot1x tx-period, Set dot1x authcontrol, Syntax clear dot1x tx-period