If you set the interval to 0, RF Auto-Tuning does not reevaluate the channel at regular intervals. However, RF Auto-Tuning can still change the channel in response to RF anomalies.

Examples: The following command sets the channel interval for radios in radio profile rp2 to

2700 seconds (45 minutes):

DWS-1008# set radio-profile rp2 auto-tunechannel-interval 2700 success: change accepted.

set radio-profile auto-tune channel-lockdown

Locks down the current channel settings on all radios in a radio profile. The channel settings that are in effect when the command is entered are changed into statically configured channel assignments on the radios. RF Auto-Tuning of channels is then disabled in the radio profile.

Syntax: set radio-profile name auto-tune channel-lockdown

name Radio profile name.

Defaults: By default, when RF Auto-Tuning of channels is enabled, channels continue to be changed dynamically based on network conditions.

Access: Enabled.

Usage: To save this command and the static channel configuration commands created when you enter this command, save the configuration.

Examples: The following command locks down the channel settings for radios in radio profile rp2:

DWS-1008# set radio-profile rp2 auto-tunechannel-lockdownsuccess: change accepted.

See Also:

set radio-profile auto-tune channel-config

set radio-profile auto-tune channel-holddown

set radio-profile auto-tune channel-interval

show radio-profile

D-Link DWS-1008 CLI Manual

337

Page 340
Image 340
D-Link dws-1008 Set radio-profile auto-tune channel-lockdown, Syntax set radio-profile name auto-tune channel-lockdown