RF Detection Commands

MSS automatically performs RF detection scans on enabled and disabled radios to detect rogue access points. A rogue access point is a BSSID (MAC address associated with an SSID) that does not belong to a D-Link device and is not a member of the ignore list configured on the seed switch.

MSS can issue countermeasures against rogue devices to prevent clients from being able to use them.

You can configure RF detection parameters on individual switches.

This chapter presents RF detection commands alphabetically. Use the following table to locate the commands in this chapter based on their use.

Rogue Information

show rfdetect clients on page 275

 

show rfdetect data on page 280

 

show rfdetect visible on page 283

 

show rfdetect counters on page 278

Countermeasures

show rfdetect countermeasures on page 277

Permitted Vendor List

set rfdetect vendor-list on page 274

 

show rfdetect vendor-list on page 282

 

clear rfdetect vendor-list on page 269

Permitted SSID List

set rfdetect ssid-list on page 273

 

show rfdetect ssid-list on page 282

 

clear rfdetect ssid-list on page 269

Client Black List

set rfdetect black-list on page 270

 

show rfdetect black-list on page 285

Attack List

set rfdetect attack-list on page 270

 

show rfdetect attack-list on page 274

 

clear rfdetect attack-list on page 268

Ignore List

set rfdetect ignore on page 271

 

show rfdetect ignore on page 281

 

clear rfdetect ignore on page 268

AP Signatures

set rfdetect signature on page 272

Log Messages

set rfdetect log on page 272

DWS-to-Client RF Link

test rflink on page 284

D-Link DWS-1008 CLI Manual

267

Page 270
Image 270
D-Link dws-1008 manual Rogue Information, Countermeasures, Permitted Vendor List, Permitted Ssid List, Client Black List