D-Link dws-1008 Show rfdetect data, Displays information about the APs detected by a switch, Age

show rfdetect data

Displays information about the APs detected by a switch.

Syntax: show rfdetect data

Defaults: None.

Access: Enabled.

Usage: You can enter this command on any switch. The output applies only to the switch on which you enter the command. To display all devices that a specific D-Link radio has detected, even if the radio is managed by another switch, use the show rfdetect visible command.

Only one MAC address is listed for each D-Link radio, even if the radio is beaconing multiple SSIDs.

Examples: The following command shows the devices detected by this switch during the most recent RF detection scan:

DWS-1008# show rfdetect data Total number of entries: 197 Flags: i = infrastructure, a = ad-hoc

c = CCMP, t = TKIP, 1 = 104-bit WEP, 4 = 40-bit WEP, w = WEP(non-WPA)

BSSID	Vendor Type Port/Radio			Flags		RSSI	Age	SSID
			/Ch
-----------------	-------	-----	-------------	------		----	---	-----------------
00:07:50:d5:cc:91	Cisco	intfr	3/1/6	i----	w	-61	6	r27-cisco1200-2
00:07:50:d5:dc:78	Cisco	intfr	3/1/6	i----	w	-82	6	r116-cisco1200-2
00:09:b7:7b:8a:54	Cisco	intfr	3/1/2	i-----		-57	6
00:0a:5e:4b:4a:c0	3Com	intfr	3/1/11	i-----		-57	6	public
00:0a:5e:4b:4a:c2	3Com	intfr	3/1/11	i-t1--		-86	6	trapezewlan
00:0a:5e:4b:4a:c4	3Com	intfr	3/1/11	ic----		-85	6	trpz-ccmp
00:0a:5e:4b:4a:c6	3Com	intfr	3/1/11	i-t---		-85	6	trpz-tkip
00:0a:5e:4b:4a:c8	3Com	intfr	3/1/11	i----	w	-83	6	trpz-voip
00:0a:5e:4b:4a:ca	3Com	intfr	3/1/11	i-----		-85	6	trpz-webaaa
...

D-Link DWS-1008 CLI Manual 280