Defaults: None.

Access: Enabled.

Usage: You must set the system county code to a valid value before using any set ap commands to configure an access point.

Examples: To set the country code to Canada, type the following command:

DWS-1008# set system country code CA success: change accepted.

See Also:

• show config

set system idle-timeout

Specifies the maximum number of seconds a CLI management session with the switch can remain idle before MSS terminates the session.

Syntax: set system idle-timeout seconds

seconds Number of seconds a CLI management session can remain idle before MSS terminates the session. You can specify from 0 to 86400 seconds (one day). If you specify 0, the idle timeout is disabled.

The timeout interval is in 30-second increments. For example, the interval can be 0, or 30 seconds, or 60 seconds, or 90 seconds, and so on. If you enter an interval that is not divisible by 30, the CLI rounds up to the next 30-second increment. For example, if you enter 31, the CLI rounds up to 60.

Defaults: 3600 seconds (one hour).

D-Link DWS-1008 CLI Manual

25

Page 28
Image 28
D-Link dws-1008 manual Set system idle-timeout, Syntax set system idle-timeout seconds