HP ew2500 802.11b/g Print Server manual User-timeout, Ews-config, Tcp-mss, Gw-disable

Table 3-3Telnet Commands and Parameters (continued)

user-timeout	Seconds that a Telnet or FTP session is idle before it is automatically disconnected. Set
	from 1 to 3600 seconds.
	0: Disable.
	900 (default): Enable.
	CAUTION: Setting this to a short time period might disable Telnet/FTP, because a
	session could terminate before changes can be made.
cold-reset	Reset to TCP/IP factory default settings after a cold reset. (Parameters for other
	subsystems, such as IPX/SPX or AppleTalk, are not affected.)
	0: Disable. Retain TCP/IP settings after a cold reset.
	1: Enable. Restore factory default TCP/IP settings.
icmp-ts-config	ICMPv4 time stamp requests.
	0 (default): Disable
	1: Enable
ews-config	Allow use of the HP Embedded Web Server on the HP Jetdirect print server.
	0 Disable.
	1 (default): Enable.
	For more information, see HP Embedded Web Server (V.40.xx) on page 64.
web-refresh	Time interval for the HP Embedded Web Server diagnostic page updates. Set from 1 to
	99999 seconds.
	0: Disable.
tcp-mss	Maximum segment size (MSS) that the HP Jetdirect print server advertises for use when
	communicating with local subnets (Ethernet MSS=1460 bytes or more) or remote subnets
	(MSS=536 bytes).
	0 (default): All networks are assumed to be local (Ethernet MSS=1460 bytes or more).
	1: Use MSS=1460 bytes (or more) for subnets, and MSS=536 bytes for remote networks.
	2: All networks are assumed to be remote (MSS=536 bytes), except the local subnet.
	MSS affects performance by preventing IP fragmentation that can result in data
	retransmission.
tcp-msl	Maximum segment life (MSL) in seconds. Set from 5 to 120 seconds.
	0: Disable.
	15 (default): Enable.
gw-disable	Automatically assign the device IP address as the gateway when a network gateway is
	not configured.
	0: Assign a gateway using the device IP address.
	1: Do not assign a gateway. The gateway address 0.0.0.0 is configured.

IPv4 configuration 53