HP ew2500 802.11b/g Print Server manual Other

Table 3-3Telnet Commands and Parameters (continued)

appletalk	Use AppleTalk (EtherTalk) protocol operation on the print server.
	0: Disable.
	1 (default): Enable.
	NOTE: On HP Jetdirect 635n print servers, all network protocols except TCP/IP are
	disabled by factory default.
Name	(Read-only parameter.) Name of the printer on the AppleTalk network. A number after the
	name indicates that this is the Nth instance of the name.
Print Type	(Read-only parameter.) AppleTalk network printer type reported by the HP Jetdirect print
	server. Up to three print types can be reported.
Zone	(Read-only parameter.) Name of the AppleTalk network zone on which the printer is
	located.
Phase	(Read-only parameter.) AppleTalk phase 2 (P2) is pre-configured on the HP Jetdirect print
	server.
Status	(Read-only parameter.) Current AppleTalk configuration status.
	READY: HP Jetdirect print server is awaiting data.
	DISABLED: AppleTalk was manually disabled.
	INITIALIZING: Print server is registering the node address or name. An additional
	status message might also be displayed.
DLC/LLC
dlc/llc-config	Use DLC/LLC protocol operation on the print server (if supported).
	0: Disable.
	1 (default): Enable.
	NOTE: On HP Jetdirect 635n print servers, all network protocols except TCP/IP are
	disabled by factory default.
strict-8022	Controls DLC/LLC protocol interpretation:
	0 (default): Disable. Provide loose interpretation.
	1: Enable. Provide strict interpretation.
Other

IPv4 configuration 57