HP ew2500 802.11b/g Print Server manual Network-select, Link-type

Table 3-3Telnet Commands and Parameters (continued)

network-select	(For HP Jetdirect products with a dual wired/wireless port. Specifies the active behavior of
	the print server.)
	● Auto (default): Automatically detects whether a network cable is attached. If a
	network cable is not attached, only the IEEE 802.11g wireless port is active. If a
	network cable is attached, then only the IEEE 802.3 wired port is active.
	CAUTION: Do not plug a network cable into an active wired/wireless port if the
	network-select command is set to Auto. Wireless access will immediately terminate.
	● Wired: Only the 802.3 wired port is active.
	● Wireless: Only the 802.11g wireless port is active.
link-type	(For wired 10/100/1000T Ethernet.) Set the print server's link speed (10, 100, 1000
	Mbps) and communication mode (Full- or Half-Duplex). The available link-speed depends
	on the print server model. Select from the following communication modes:
	AUTO (default): Use auto-negotiation to configure the highest link speed and
	communication mode allowed.
	1000FULL: 1000 Mbps, full-duplex operation.
	100AUTO: Limit auto-negotiation to a maximum link speed of 100 Mbps.
	100FULL: 100 Mbps, full-duplex operation.
	100HALF: 100 Mbps, half-duplex operation.
	10FULL: 10 Mbps, Full-duplex operation.
	10HALF: 10 Mbps, half-duplex operation.
usb-mode	Communication mode over the USB port on the HP Jetdirect print server.
	● Auto (default): Automatically negotiate and set the highest communication mode
	possible for the attached printer or device.
	● MLC: HP proprietary (multiple logical channels) mode that allows multiple channels of
	simultaneous print, scan, and status communication.
	● BIDIR: Standard connection that supports bi-directional communication between the
	printer and print server.
	● UNIDIR: Standard connection in which data is transferred in one direction only (to
	the printer).
usb-speed	(Read-only parameter, USB 2.0 products only.) Auto-negotiated communication speed
	over the USB connection between the HP Jetdirect print server and the device.
	● Full Speed: 12 Mbits/sec as specified in the USB v2.0 specifications, compatible
	with USB v1.1 specifications.
	● Hi-Speed: 480 Mbits/sec for USB v2.0 devices only.
	● Disconnected: USB port is not connected.
hw-acclrn-conf	Use hardware acceleration.
	0: Disable.
	1 (default): Enable.

IPv4 configuration 59