HP ew2500 802.11b/g Print Server manual Subnet Mask, Default Gateway, Config by, Bootp Server

Table 8-8 IPv4 Section (continued)

Message	Description
SUBNET MASK	IPv4 subnet mask configured on the HP Jetdirect print server. During initialization, a
	temporary value 0.0.0.0 is displayed. Depending on configuration parameters, the
	print server can automatically assign a usable default value.
	Not Specified Subnet mask is not configured.
DEFAULT GATEWAY	IPv4 address of the gateway used when sending packets off the local network. Only
	one default gateway can be configured. During initialization, a temporary value
	0.0.0.0 is displayed. If not provided, the IP address of the HP Jetdirect print server is
	used.
	Not Specified Default gateway is not configured.
CONFIG BY:	Indicates how the HP Jetdirect print server obtained its IPv4 configuration:
	BOOTP Automatic configuration through a BOOTP server.
	BOOTP/TFTP Automatic configuration through a BOOTP server and TFTP configuration
	file.
	DHCP Automatic configuration through a DHCP server.
	DHCP/TFTP Automatic configuration through a DHCP server and TFTP configuration
	file.
	RARP Automatic configuration through the RARP.
	USER SPECIFIED Manual configuration through Telnet, the printer's control panel,
	HP Web Jetadmin, HP Embedded Web Server, or other method.
	DEFAULT IP Default IP address was assigned. This address might not be a valid
	address for your network.
	AUTO IP Link-local IP address (169.254.x.x) was assigned. If the network is a link-local
	network, this address should be valid.
	NOT CONFIGURED Not configured with IP parameters. Verify that TCP/IP is enabled,
	or check for error status.
BOOTP SERVER	Displayed if BOOTP, DHCP, or RARP is used for TCP/IP configuration. Specifies the IP
or	address of the system that responds to the HP Jetdirect print server's request for
	automatic TCP/IP configuration over the network.
DHCP SERVER	Not Specified Configuration server's IP address could not be determined or was set to
or	zero in the response packet.
RARP SERVER
BOOTP/DHCP SERVER	Displayed during initialization while the HP Jetdirect print server attempts to obtain its
	TCP/IP configuration from a BOOTP or DHCP server. The temporary address displayed
	is 0.0.0.0.
TFTP SERVER	IP address of the system where the TFTP configuration file is located. During
	initialization, the temporary address 0.0.0.0 is displayed.
	Not Specified TFTP server is not set.

146 Chapter 8 HP Jetdirect configuration pages