HP ew2500 802.11b/g Print Server Ipx-config, Ipx-unitname, Address, Ipx-mode, Pjl-banner, Pjl-eoj

Table 3-3Telnet Commands and Parameters (continued)

ipx-config	IPX/SPX protocol operation on the print server.
	0 Disable.
	1 (default): Enable.
	NOTE: On HP Jetdirect 635n print servers, all network protocols except TCP/IP are
	disabled by factory default.
ipx-unitname	Name assigned to the print server. Enter up to 31 alphanumeric characters. By default,
	the name is NPIxxxxxx, where xxxxxx are the last six digits of the LAN hardware address.
Address	(Read-only parameter.) The IPX network and node numbers detected on the network, in
	the form <network number>:<LAN hardware address>.
ipx-frametype	IPX frame type settings available for your print server model: AUTO (default), EN_SNAP,
	EN_8022, EN_8023, EN_II. For more information, see HP Jetdirect configuration
	pages on page 135.
ipx-sapinterval	Time in seconds that the HP Jetdirect print server waits between service advertising
	protocol (SAP) broadcasts on the network. Set from 1 to 3600 seconds.
	0: Disable.
	60 (default): Enable SAP broadcasts.
ipx-mode	(Read-only parameter.) NetWare mode configured on the print server (RPRINTER or
	QSERVER).
ipx-nds-tree	NDS tree name for the print server. Enter up to 31 alphanumeric characters.
ipx-nds-context	NDS context for the HP Jetdirect print server. Enter up to 256 alphanumeric characters.
ipx-job-poll	Specifies the time interval in seconds that the HP Jetdirect print server waits to check for
	print jobs in a print queue. Set from 1 to 255 seconds.
	0: Disable.
	2 (default): Enable.
pjl-banner	Print an IPX banner page through PJL.
(ipx-banner)	0: Disable.
	1 (default): Enable banner pages.
pjl-eoj	IPX end-of-job notification through PJL.
(ipx-eoj)	0: Disable.
	1 (default): Enable.
pjl-toner-low	IPX toner-low notification through PJL.
(ipx-toner-low)	0: Disable.
	1 (default): Enable.
AppleTalk

56 Chapter 3 TCP/IP configuration