HP ew2500 802.11b/g Print Server manual 18Other protocols, Enable Print Protocols, Server on

The SNMP v3 agent is enabled when you create an initial SNMP v3 account on the print server. Once created, any properly configured SNMP management application can access or disable the account.

CAUTION: Creating SNMP v3 accounts with the HP Embedded Web Server removes existing accounts. Also, you must implement the account information on the SNMP management application.

It is recommended that you use HP Web Jetadmin to configure SNMP v3 and other security settings on the print server.

To prevent access or interception during SNMP v3 account creation, disable Telnet and enable secure embedded Web communication using HTTPS.

Create the initial SNMP account by specifying the HMAC-MD5 authentication and CBC-DES data privacy encryption keys used by your SNMP v3 management application.

CAUTION: SNMP v1 and v2c agents can coexist with the SNMP v3 agent. However, to fully secure SNMP access, you should disable SNMP v1 and v2c.

Other

Use this tab to enable or disable various protocols supported by the print server for printing, print services, and management. The items are described in Table 4-18 Other protocols on page 100.

Table 4-18Other protocols

Item	Description
Enable Print Protocols	Select the print protocols to use: IPX/SPX, AppleTalk, or DLC/LLC. (Disable unused
	protocols to prevent access.)
	For network environments that use these protocols, see Introducing the HP Jetdirect print
	server on page 1.
	Because the HP Embedded Web Server uses TCP/IP, you cannot disable this protocol.
	NOTE: On HP Jetdirect 635n print servers, all network protocols except TCP/IP are
	disabled by factory default.
Enable Print Services	Select the print services to use: port 9100, LPD, IPP, FTP, or Web Services Print.
	(Disable unused print services to prevent access.)

100 Chapter 4 HP Embedded Web Server (V.40.xx)