HP ew2500 802.11b/g Print Server Upgrade Laa, Xml-services-conf, Ws-discovery-conf, 1000t-ms-conf

Table 3-3Telnet Commands and Parameters (continued)

upgrade

laa

Set the name and location of the firmware upgrade file for the HP Jetdirect print servers.

CAUTION: Ensure that command parameters are properly entered and that the upgrade file is a higher version than the currently installed version. The print server attempts to upgrade if the upgrade file contains a higher version than the installed version.

The following is the command format:

upgrade: <TFTP server IP> <Version> <Product Number> <Filename>

The following defines the parameters:

<TFTP Server IP> IP address of the TFTP server, <Version> firmware version of the upgrade file, <Product Number> print server product number <Filename> path and filename of the firmware upgrade file.

Specify a locally administered address (LAA) to replace the factory-assigned LAN hardware (MAC) address. If LAA is used, enter a string of exactly 12 hexadecimal digits.

For Ethernet print servers, the LAA must start with hexadecimal X2, X6, XA, or XE, where X is any hexadecimal digit 0 through F.

The default address is the factory-assigned address.

xml-services-conf	Allow access by HP Web service applications to XML-based data on the HP Jetdirect print
	server.
	0: Disable.
	1 (default): Enable.
ws-discovery-conf	Allow Microsoft WS discovery protocols on the print server.
	1 (default): Enable.
	0: Disable.
1000t-ms-conf	Configure the print server as a master or slave device on a 1000T network.
	AUTO or 0 (default): Master/slave configuration is automatically sensed and assigned.
	MASTER or 1: Configure as a 1000T master device.
	SLAVE or 2: Configure as a 1000T slave device.
1000t-pause-conf	Control the flow of inbound and outbound data.
	OFF or 0 (default): Disable flow control.
	AUTO or 1: Configure through auto-negotiation with the network switch.
	RCV or 2: Enable only for data received from the network.
	TRANS or 3: Enable only for data transmitted to the network.
	TXRX or 4: Enable for both received and transmitted data.

58 Chapter 3 TCP/IP configuration