HP ew2500 802.11b/g Print Server manual AppleTalk, Other Settings

Table 3-2TFTP configuration file parameters (continued)

ipx-nds-context:

NDS context for the HP Jetdirect print server. Enter up to 256 alphanumeric characters.

ipx-job-poll:

Time in seconds that the HP Jetdirect print server waits to check for print jobs in a print queue. The range is 1 to 255 seconds. 0: Disable. 2 (default): Enable.

pjl-banner: (or ipx-banner:)

Print an IPX banner using the printer job language (PJL). 0: Disable. 1 (default): Enable banner pages.

pjl-eoj: (or ipx-eoj:)

IPX end-of-job notification. 0: Disable. 1 (default): Enable.

pjl-toner-low: (or ipx-toner-low:)

IPX toner-low notification. 0: Disable. 1 (default): Enable.

AppleTalk

appletalk: (or at-config:,ethertalk:)

Use AppleTalk (EtherTalk) protocol operation on the print server. 0: Disable. 1 (default): Enable.

NOTE: On HP Jetdirect 635n print servers, all network protocols except TCP/IP are disabled by factory default.

DLC/LLC

dlc/llc-config: (or dlc/llc:)

Use DLC/LLC protocol operation on the print server. 0: Disable. 1 (default): Enable.

NOTE: On HP Jetdirect 635n print servers, all network protocols except TCP/IP are disabled by factory default.

Other Settings

link-type:

(For wired 10/100/1000T Ethernet.) Set the print server's link speed (10, 100, 1000 Mbps) and communication mode (Full- or Half-Duplex). The available link-speed depends on the print server model. The communication modes are: AUTO,

1000FULL, 100AUTO, 100FULL, 100HALF, 10FULL, 10HALF.

For AUTO (default), the print server uses auto-negotiation to configure the highest link speed and communication mode allowed. If auto-negotiation fails, either 100TX HALF or 10TX HALF is set, depending on the detected link speed of the hub/switch port. (A 1000T half-duplex selection is not supported.)

34 Chapter 3 TCP/IP configuration