HP ew2500 802.11b/g Print Server Novell/NetWare parameters, 10 IPX/SPX configuration information

Table 8-10 IPX/SPX configuration information

Message	Description
STATUS	Current IPX/SPX protocol status.
	READY Print server is awaiting data.
	DISABLED Manually disabled.
	INITIALIZING Registering the node address or name. An additional status message
	might also displayed.
	An error code and message is displayed if the print server is not ready. For more
	information, see Table 8-14 Error messages on page 150.
PRIMARY FRAME TYPE	Frame type selection.
	AUTO SELECT Automatically sense and limit to the first one detected.
	EN_8023 Limit to IPX over IEEE 802.3 frames. All others are counted and discarded.
	EN_II Limit to IPX over Ethernet frames. All others are counted and discarded.
	EN_8022 Limit to IPX over IEEE 802.2 with IEEE 802.3 frames. All others are counted
	and discarded.
	EN_SNAP Limit to IPX over SNAP with IEEE 802.3 frames. All others are counted and
	discarded.
NETWORK	Network column specifies the network number associated with a protocol frame type
FRAME TYPE	used for communication between a server and the HP Jetdirect print server.
	UNKNOWN Determining which network number to use.
RCVD	Frame Type column identifies the frame type used with the associated network
	number: EN_8023, EN_8022, EN_II, EN_SNAP. Unless a specific frame type is
	manually set, the print server automatically determines the protocol frame type by
	listening to the network data. DISABLED Frame type for that network is manually
	configured.
	RCVD column displays the packets received for each frame type.

Novell/NetWare parameters

Information in this section of the HP Jetdirect configuration page is described in Table 8-11 Novell/ NetWare configuration information on page 148. For error messages, see Table 8-14 Error messages on page 150.

Table 8-11 Novell/NetWare configuration information

Message	Description
STATUS	Current Novell NetWare configuration status.
	READY Print server is awaiting data.
	DISABLED Manually disabled.
	INITIALIZING Registering the node address or name. Additional status messages might
	be displayed.
	An error code and message is displayed if the print server is not ready. For more
	information, see Table 8-14 Error messages on page 150.

148 Chapter 8 HP Jetdirect configuration pages