3Com S330 manual Configuring In-band Management

Configuring In-band Management 73

Figure 45 Add Virtual Circuit Menu

3Build a PVC on the far-end PathBuilder S330/S310, using the MCPU as side A of the circuit. Set the following parameters on the Add Virtual Circuit screen:

■Shaper Number—Choose the number corresponding to the desired shaper value. You assign the shaper number from the MCPU Shapers screen. See “Configuring MCPU Shapers” in Chapter 4, for details.

■IP Address—You must use a different subnet than the one you used for the near-end PathBuilder S330/S310.

■Subnet Mask—Specify any acceptable address (for example, 255.255.255.0)

■VPI/VCI—You must use the same values as you did for the near-end PathBuilder S330/S310.

4On the Manage IP Network Configuration menu, select [3] Default Gateway Configuration and set the following:

a Set the default gateway on the far-end PathBuilder S330/S310 to the PVC IP address you set for the near-end PathBuilder S330/S310 in step 1.

b Set the default gateway on the management station to the local host IP address of the near-end PathBuilder S330/S310.

For details about setting the default gateway, see “Configuring the Default Gateway” earlier in this chapter.

5Apply your IP configuration changes.

a From the main menu, select [1] System Administration.

b From the System Administration menu, select [3] Manage IP Network Configuration.

c From the Manage IP Network Configuration menu, select [1] Local Host IP Configuration.

d From the Local Host IP Configuration menu, select [2] Apply IP Configuration Changes.